2-Minute Shower Installation

Follow our easy to understand, step-by-step directions to install your new high-pressure, 1.5 gpm "Jet-Stream" Showerhead® in just two minutes.
[Printable Version]

The high-pressure, 1.5 gpm "Jet-Stream" Showerhead® fits all standard ½-inch threaded shower arms (Adaptors are available to retrofit obsolete ball-type shower arms).

Remove the current showerhead from the shower arm extension, by hand or by using a crescent or pipe wrench.

Remove all grime or dirt from the shower arm extension with a rag or cloth. Wrap with plumbing tape if necessary to provide a smooth and clean connection

By hand, install the 1.5 gpm "Jet-Stream" Showerhead® and ensure the black seal (control valve) is centered in the top of the connector before installing slowly. Turn the connector by hand clockwise until snug.

Caution: Do not use a wrench or over-tighten as this may damage the control valve/seal.

Turn on the water and ensure there are no leaks. If there are no leaks, tighten as necessary by hand or with a wrench.

Do not over-tighten as damage to the control valve/seal may occur and the showerhead will not perform as designed.

Take a quick shower rather than a bath and save an average of 20 gallons (76 liters) of water.

Most Common Problem: Sometimes, sediment or foreign matter gets into the "air Chamber" and causes the shower to be erratic and weak. Solution: Remove the black "control valve" from the unit, then cover the "mouth" with your hand and blow hard several times. This will cause the sediment to exit the top of the unit. Then re-insert the control valve and re-install.